Field comparison ================ Field comparison reads a validated observation report and the planned plot targets, then reports plot-level residuals and unit-level bias. It does not silently correct the LiDAR layer, the vegetation model, or the treatment schedule. The comparison uses different definitions on purpose: - field shrub cover versus the LiDAR mean cover target; - field shrub height versus the LiDAR maximum shrub-height target. Positive cover or height deltas mean the field measurement is above the LiDAR target. Suggested multipliers are review aids. They are not applied automatically. Sample status ------------- ``insufficient`` means fewer than three complete cover/height pairs. ``provisional`` means at least three, but fewer than eight complete pairs for either metric. ``adequate`` requires at least eight complete pairs for both metrics. These thresholds are evidence-review gates, not statistical confidence claims. Treatment response remains ``not_tested`` until before/after field observations exist. The modelled shrub reduction and annual regrowth are not calibrated by this report. Command ------- .. code-block:: bash brushline field compare \ --observations field-observations-validated.json \ --plots corridor-plots.geojson \ --out field-comparison.json The output contains plot rows, unit summaries, cover and height multipliers, recommendations, warnings, and caveats. It is a review input for the next calibration decision.